Husqvarna 3-Speed Core Drill Motor - DM230
Product Description
New, handheld drill motor with attractive design and functional ergonomics. Soft rear section and a larger contact area mean that it sits better against your body. The machine is modular, and therefore easy to maintain and repair.
If the motor runs at too high a load for a long period, it will start to pulsate. If the load is not reduced the motor will shut off, to prevent overheating. Elgard™ significantly increases the machine’s service life.
-Functional ergonomics make the Husqvarna drill motors easy and convenient to operate.
-An electronic current limiter for softer starts. Full speed is reached about two seconds after the switch is turned on.
-Water-cooled gearbox (patent pending), where the water passes through the blade spindle, extends life of gearbox and gaskets.
-Standard attachment for the stand, and is mainly meant for wet drilling, but can be fitted with an adapter for dry drilling.
-Buttons and controls are ergonomically designed and easy to reach.
-Water hose and electric cable run parallel conveniently from the machine.
-Thanks to electronic rpm control, the job can always be done with optimum power.
Engine Voltage; 230 / 110 V, Amperage; 8 / 15 A, Power; 1850 W, Output RPM at full load; 500 / 1400 / 2900 rpm, Speeds; 3, Rated output, Watt; 1100/0 W, Rated current, Amp; 8/15 A, Spindle speed idle high speed; 900/2150/4500 rpm Drill bit.
Weight; 15.4 lbs
If the motor runs at too high a load for a long period, it will start to pulsate. If the load is not reduced the motor will shut off, to prevent overheating. Elgard™ significantly increases the machine’s service life.
-Functional ergonomics make the Husqvarna drill motors easy and convenient to operate.
-An electronic current limiter for softer starts. Full speed is reached about two seconds after the switch is turned on.
-Water-cooled gearbox (patent pending), where the water passes through the blade spindle, extends life of gearbox and gaskets.
-Standard attachment for the stand, and is mainly meant for wet drilling, but can be fitted with an adapter for dry drilling.
-Buttons and controls are ergonomically designed and easy to reach.
-Water hose and electric cable run parallel conveniently from the machine.
-Thanks to electronic rpm control, the job can always be done with optimum power.
Engine Voltage; 230 / 110 V, Amperage; 8 / 15 A, Power; 1850 W, Output RPM at full load; 500 / 1400 / 2900 rpm, Speeds; 3, Rated output, Watt; 1100/0 W, Rated current, Amp; 8/15 A, Spindle speed idle high speed; 900/2150/4500 rpm Drill bit.
Weight; 15.4 lbs